Further information

LokPilot V3.0 - Technical data

Operational modes: NMRA/DCC with 14, 28 and 128 speed steps, armed for DCC duplex communication.
  2 digit and 4 digit addresses
  Digital Motorola® (old and new), up to 255 addresses for Motorola® use
  Analog DC (de-selectable). Analog AC (de-selectable)
  Automatic recognition of operational mode and DCC speed selection
  Supports Lenz® LG100, Märklin®, Roco® braking section and ZIMO® HLU commands
  Base-direction bit / stores operational status
  Intelligent programming mode with Märklin® 6021
  Switching speed and acceleration & deceleration key selectable
Throttle: 1.1 A continuous load
  Runs DC, coreless and AC motors (with permanent magnet)
  Silent, safe 16 / 32 kHz pulse width frequency motor regulation
  Motor output overload protection
  Fourth generation back EMF (de-selectable)
Function outputs: 4 outputs
  250mA load per output
  500mA total load of all function outputs
  Free function allocation (function mapping)
  Outputs short circuit protected
Dimensions: 23.5mm x 15.5mm x 5.5mm (0.94 x 0.62 x 0.22 inch)

Decoder can be used on Selectrix® layouts. Programming in DCC mode only. Programming with exclusive Selectrix® devices not possible.