Deutsch
Further information
| Operational modes: | NMRA/DCC with 14, 28 and 128 speed steps, DCC RailCom® |
| DCC 2-digit and 4-digit addresses (long and short addresses) | |
| Digital Motorola® (old and new), up to 255 addresses for Motorola® use | |
| Selectrix® operation | |
| Analog DC (de-selectable); Analog AC (de-selectable) | |
| Automatic recognition of operational mode and DCC speed selection | |
| Supports Lenz® LG100, Märklin®, Roco® braking section and ZIMO® HLU commands | |
| Supports the ABC braking mode | |
| Base-direction bit / stores operational status | |
| Intelligent programming mode with Märklin® 6021 | |
| Switching speed and acceleration & deceleration key selectable | |
| Throttle: | 1.1 A continuous load |
| Runs DC, coreless and AC motors (with permanent magnet) | |
| Silent, safe 40 / 20 kHz pulse width frequency motor regulation | |
| Motor output overload protection; Fifth generation back EMF (de-selectable) | |
| Function outputs: | 4 outputs |
| 21MTC connector version has two additional logic outputs | |
| 250mA load per output | |
| 500mA total load of all function outputs short-circuit-proof | |
| Free function allocation (function mapping) | |
| Dimensions: | 21.3mm x 15.5mm x 5.5mm |
Possible under Selectrix® operation. Programming must be carried out in DCC mode. Programming with "pure" Selectrix® devices is not possible.